A chair rail is also termed as ‘dado rail’, is a kind of pattern which is set straight to the wall around the edge of a room.
The ‘chair rail’ is a part of the dado and though the idea of the dado is mostly to decorate the modern homes, the chair rail still protects the wall from the furniture and any other contact. Typically, the height of the chair rail is about 37″ or 900 mm, which was an appropriate height to guard the wall from the backs of chairs. Since the unusual idea of the chair management is not appropriate in modern homes, chair rail is commonly seen at 1300 mm or 1600 mm from the surface.
Chair rails are also occasionally used on a wall without the full chair management. The idea of the chair rail in these situations can still be protecting, and this is very common in situations where walls are exposed to numerous wear and tear agents, for example in shopping malls and hospitals. If you want to install a chair rail in your house then follow the following instructions.
Instructions
Get Resources and the Space Ready
- Take a measurement of the ‘linear footage’, which is required to cover up the width of the designed chair rail fixing. Include 20 percent to this number for waste and errors.
- Choose the equipments and finish it the way you would like for the new ‘chair rail’ at a home enhancement centre.
- Get the trim in widths which need few links as possible. Extra long walls need to be spliced of 15 to 17 feet, and these longer portions are more liable to be covered to avoid damage.
- Polish, finish or dye the entire wood in the color of your choice, then let the finish to dry systematically.
- Decide the length of the chair rail and make a direct level line on every wall where you want to set up the chair rail.
Putting up the Chair Rail
- Remove the first portion of length by using a usual 90-degree slash going into the angle. If you use a simple ‘miter-cut’ to cut inside angles, it will lead to horrible openings and crooked joints because the angles of a space are never equivalent to 90-degrees.
- Cut the other portion in the shape of the outline of the molding by using a ‘coping saw’, so that it can trim carefully against the first portion.
- Employ the miter box and a sharp backsaw to cut the second portion, which exposes the outline of the molding.
- Remove the extra wood down the back side of this outline by using a ‘coping saw’. Go astray on the side by eliminating too much instead of too little; only the furthest border of the coped molding can be noticed.
- You can take out any extra substance by using a sharp knife, which you skipped with the coping saw. Make sure that you do not hack into the uncovered molding face. Hold the portion in position to examine the fit, and carve it properly if required.
- Once you are done fitting the rail, connect it with the wall using six dimensional finish nails in the wall holes. Fix all nails by using a nail set. You can also apply ‘wood putty’ to cover up openings and finish to match of the wall.
Installing the chair rails
- Make a spot outside angles by hitting one end of the molding in space. Make the spot precisely even with the angle of the wall.
- You can use this spot as the small point of the ‘miter cut’ for the exterior angle. The back side of the outside angle will be chopped with an opposite angle. When the fitting is done, then connect the rail to the wall with six dimensional finish nails in the openings of the wall.
- You can also use ‘Corner Blocks’ in the place of ‘wood putty’. Corner blocking adjoins a much complete attractive feel to the trim. It also decreases entire cuts of the corner for easy direct cut ‘butt joints’.
Select one of various styles while selecting your chair rail molding. Get the complete quantity of inside and outside portion to accomplish the work.
Related Tags: chair rail ideas, how to install chair rail molding, how to install chair rail, chair rail molding, installing chair rail, fixing chair rail, Chair Rail Molding Ideas, chair rail installation
Related Content: